Skip to content
Auto Median
  • DIY Repair Tools
  • Emergency Tools
  • Diagnostic Tools
  • Detailing Tools
  • Interior Accessories
  • Exterior Accessories

Phone Mounts

Why Does My Phone Sag After a Bit on this Mount?

by Chris Perling

You put your phone on the mount, and it looks fine. But after a few minutes of driving, it slowly starts to sag or tilt down. This is frustrating and can even block your view of the road. The problem is almost always a weak spring or a loose ball joint in the mount. Many … Read more

Categories Phone Mounts

How Long Do I Have to Wait for My Phone Mount Adhesive to Seal?

by Chris Perling

You just stuck a brand new phone mount on your dashboard, and now you are staring at the clock. The big question is how long you have to wait for that adhesive to actually seal and hold your phone. In my experience, the temperature of your car changes everything. Most adhesives need 24 hours to … Read more

Categories Phone Mounts

Why Are the Base Edges of My Phone Mount Only Slightly Rounded?

by Chris Perling

I have wondered the same thing about my phone mount. The base edges are only slightly rounded, not fully curved. This small detail matters because it affects how securely your phone stays in place. That slight rounding is actually a smart design choice. It provides just enough give to avoid scratching your phone’s back glass, … Read more

Categories Phone Mounts

Why Did I Ding One Star Due to Mounting Limitations on this Phone Mount?

by Chris Perling

I gave this phone mount four stars instead of five because of its mounting limitations. You need to know exactly where it fits before you buy, or you might waste your money on something that doesn’t work for your car. The main problem was the short, non-adjustable arm that couldn’t reach past my dashboard curve. … Read more

Categories Phone Mounts

Why Do Other Phone Mounts Melt Off in the Heat or Sag over Time?

by Chris Perling

I have seen cheap phone mounts start to droop after just one hot summer day. The plastic softens and the grip weakens, leaving your phone dangerously loose. This matters because a falling phone can crack your screen or cause a car accident. Many mounts use low-grade plastics that cannot handle direct sunlight inside a parked … Read more

Categories Phone Mounts

Why Does a Cup Holder Mount Take up Half My Cup Holder Space?

by Chris Perling

You finally bought a phone mount for your car, only to find its clamp eats up half your cupholder. This frustrating design flaw makes your morning coffee a balancing act. It matters because a mount should solve problems, not create new spills. Most cupholder mounts use a rubber expansion base that wedges sideways, stealing interior … Read more

Categories Phone Mounts

Why Does My Phone Mount Vibrate at Full Extension on the Highway?

by Chris Perling

You are cruising down the highway, and your phone mount starts shaking like crazy. This annoying vibration makes it hard to see your GPS, and it can even damage your phone over time. The problem gets much worse when the mount arm is fully extended. A long arm acts like a lever, making every small … Read more

Categories Phone Mounts

Why is My Phone Mount Rigid Stem Making My Phone Shake?

by Chris Perling

You pull up to a stoplight and your phone is buzzing like a rattlesnake. It is distracting and it can even damage your phone’s camera. We need to fix that shaky stem. The rigid stem is a solid bar, so it transfers every single vibration from your car’s engine and the road directly into your … Read more

Categories Phone Mounts

Why Did My Phone Mount Require Struggling Just to Set it Up?

by Chris Perling

I remember the first time I tried to install a phone mount in my car. The struggle was real, and it made me wonder if I was missing something obvious. Getting this right matters because a shaky or poorly placed mount is dangerous and frustrating. What most people do not realize is that many mounts … Read more

Categories Phone Mounts

Why Does My Phone Mount Vent Clip Only Fit Certain Vent Types?

by Chris Perling

If you have tried to put a phone mount vent clip into your car’s air vent and it just would not stay, you are not alone. This happens because vent clips are designed to grab specific louver shapes and depths, so a mismatch makes the mount fall off or damage your vents. In my experience, … Read more

Categories Phone Mounts
Older posts
Newer posts
← Previous Page1 … Page30 Page31 Page32 … Page35 Next →

Check This Out!

  • PHATRIP vs RULLINE vs COOLWOLF: Best Toe Alignment Tool for DIY Mechanics?
  • ANENG Bluetooth vs AstroAI TRMS 6000: Best Multimeter for Data Logging?
  • PICURA vs DEERMOTO vs HECASA Toe Plates: Best No-Caliper Removal Alignment Tool
  • GRENPRO 29pc Torx Bit Set Impact Driver Review
  • VEVOR vs Toplamper Wheel Alignment Tool: Best Heavy Duty Toe Plates for DIYers?
  • About Us
  • Affiliate Disclosure
  • Contact Us
  • Terms of Use
  • Privacy Policy
© 2025. All Rights Reserved.