Automedian
Find the right tool
before you turn the wrench.
Honest buying guides and hands-on reviews for every auto tool — from daily drivers to weekend mechanics who mean business.
Explore by Category
Find the scanner, wrench, jack, or charger you actually need.
Diagnostic Tools
DIY Repair Tools
Emergency Tools
Detailing Tools
Interior Accessories
Latest Guides
Fresh how-tos and buying advice straight from the garage.
Why Does My Cordless Reciprocating Saw Motor Get Hot and Wear Out Fast?
Your cordless reciprocating saw motor getting hot and dying quickly is a frustrating problem that many DIYers and pros face.…
Read more
How Do I Fix a Cordless Rotary Tool that Dies After 20 Minutes?
Few things are more frustrating than a cordless rotary tool that suddenly stops mid-project. When your tool dies after just…
Read more
What Case Fits My Cordless Cut-Off Tool for Safe Storage?
Finding the right case for your cordless cut-off tool keeps it safe from drops, dust, and moisture. The wrong storage…
Read more
Why Do Vent Holes on My Cordless Rotary Tool Get Covered?
I’ve noticed my cordless rotary tool’s vent holes get covered with fine dust after just a short project. This blocks…
Read more
How Do I Prevent Accidental Activation with a Broken Trigger on My Cordless Cut-Off Tool?
A broken trigger on your cordless cut-off tool is a serious safety hazard that can lead to severe injuries or…
Read more
What Should I Do If My Cordless Reciprocating Saw Does Not Work Out of the Box?
You unbox your new cordless reciprocating saw, slide in a battery, and pull the trigger. Nothing happens. It’s frustrating, but…
Read more
Why Doesn’t the Blade Penetrate Deep Enough on My Cordless Cut-Off Tool?
If your cordless cut-off tool stops short instead of slicing clean through, you’re not alone. I’ve been there on job…
Read more
Why Does My Cordless Oscillating Tool Keep Falling over when Idle?
We’ve all been there: you set your cordless oscillating tool down for two seconds, and it tips right over. It’s…
Read more
Is My Oscillating Tool Charger Limited to AC 120V Only?
You just bought a new oscillating tool, and the charger says AC 120V. You might be wondering if that means…
Read more
Why Are Cordless Rotary Tool Instructions so Unhelpful for Bits?
Have you ever opened a cordless rotary tool manual hoping to learn which bit does what, only to find vague…
Read more
Can I Use a 7/8 Cutoff Wheel on a Cordless Cut-Off Tool with a Small Spindle?
I get asked this question all the time when folks upgrade to a cordless cut-off tool. The short answer is…
Read more
Why Do Sanding Spools Fail at High Speed on Cordless Rotary Tools?
If you’ve used a cordless rotary tool for sanding, you know how frustrating it is when the spool shreds or…
Read more
How Do I Remove a Battery that is Stuck and Wedged in My Cut-Off Tool?
Dealing with a stuck battery in your cut-off tool is frustrating, especially when you are in the middle of a…
Read more
Why Does My Oscillating Tool Need a Hex Key for the Adapter?
You just mounted a new accessory on your oscillating tool, grabbed the adapter, and then spotted that tiny hex key…
Read more
Should I Trust an Open Box Cordless Reciprocating Saw?
I’ve stood in the aisle staring at an open box cordless reciprocating saw, wondering if the savings were worth the…
Read more